RAM Promaster 2016 User Manual page 74

Table of Contents

Advertisement

D I E S E L
Instrument Cluster Messages
Messages will be displayed in the instrument cluster to alert the driver when certain
unusual conditions occur. These messages are described below:
MESSAGE
Transmission/Gearbox
Fault (Red)
Reduce Gear Changes
Manual Mode Not
Available
Automatic Mode Not
Available
Clutch Overheating
Press Brake Pedal
Delayed Startup
72
When the ignition key is turned to ON/RUN/MAR, the Trans-
mission Fault Indicator light turns on and should go off after
The Transmission Fault Indicator illuminates either steady
or blinking (together with this message and a buzzer) to in-
dicate a transmission fault.
Contact your authorized dealer if the message continues to
This message indicates that the driver is operating the
transmission incorrectly.
Incorrect use (by the driver) could automatically activate a
procedure for protecting the system.
Contact you authorized dealer if the message continues to
MANUAL (M) mode is not available, due to a fault or other
condition. Use the DRIVE (D) position to operate the ve-
Contact your authorized dealer if the message continues to
Automatic (DRIVE) mode is not available due to a fault or
other condition. Use MANUAL (M) mode to operate the ve-
Contact your authorized dealer if the message continues to
This message appears, together with a buzzer, when the
In this situation, limit stop and go driving and gear shifts or
if necessary stop the vehicle and turn the engine off to allow
If the message continues to appear, contact your authorized
To avoid clutch failure, do not use the accelerator to keep
the vehicle at a standstill (for example holding on a hill);
the clutch could be damaged by overheating. Use the brake
pedal instead and operate the accelerator only when you are
This messages appears when the key is first turned ON, if
the brake is fault and/or the shift lever is not in NEUTRAL
(N). The shift lever must be in the NEUTRAL (N) position,
and the brake pedal must be pressed, to allow engine crank-
ing. Place the shift lever in NEUTRAL (N) and apply the
brake pedal BEFORE turning the key to the START/AVV po-
sition; otherwise, the engine will not crank and the key must
be cycled OFF, then back on, before cranking is allowed.
DESCRIPTION
a few seconds.
appear.
appear.
hicle.
appear.
hicle.
appear.
clutch overheats.
the clutch to cool.
dealer.
ready to drive away.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents