Maintenance; Liability; Service Paks; Service Kits - Atlas Copco XAMS 1150 CD7 T3 APP Instruction Manual

Maintenance

LIABILITY

The manufacturer does not accept any liability for any
damage arising from the use of non-original parts and
for modifications, additions or conversions made
without the manufacturer's approval in writing.

SERVICE PAKS

A Service Pak is a collection of parts to be used for a
specific maintenance task, e.g. after 50, after 500 and
after 1000 running hours.
It guarantees that all necessary parts are replaced at
the same time keeping down time to a minimum.
The order number of the Service Paks are listed in the
Atlas Copco Parts List (ASL).
Use of service paks
Service Paks include all genuine parts needed for
normal maintenance of both compressor and engine.
Service Paks minimize downtime and keep your
maintenance budget low.
Order Service Paks at your local Atlas Copco dealer.

SERVICE KITS

A service kit is a collection of parts to fit a specific
repair or rebuilding task.
It guarantees that all necessary parts are replaced at
the same time which improves the uptime of the unit.
The order numbers of the Service Kits are listed in the
Atlas Copco Parts List (ASL).
Contact Atlas Copco.

STORAGE

Run the compressor regularly, e.g. twice a week, until
warm.
Load and unload the compressor a few times to
operate the unloading and regulating components.
Close the air outlet valves after stopping.
If the compressor is going to be stored
without running from time to time,
protective measures must be taken.
- 56 -

SAFETY PRECAUTIONS

Before performing any maintenance
jobs always switch the battery switch off.
See section Battery switch.
Always observe the applicable safety
precautions. See section Safety during
maintenance and repair.
Please note that when the battery switch
is off there can still be some parts live!