Towing Instructions Wagon; Towbar Levelling Wagon - Atlas Copco XAMS 1150 CD7 T3 APP Instruction Manual

TOWING INSTRUCTIONS WAGON

(2)
(1)
Before towing the compressor, ensure
that the towing equipment of the vehicle
matches the towing eye. The height of
the towing device of the vehicle must be
815 - 845 mm (31.8 - 33 in).
1. Attach the compressor to the towing vehicle.
2. Connect the brake pressure lines (when equipped
with ABS).
3. Move hand brake lever (1) in the direction of the
arrow till stop and connect the breakaway chain
(2) to the towing vehicle.
Never move the compressor with air hoses connected
to the air outlet valves.
Before moving the compressor, switch it
off.
When equipped with ABS:
 Before moving the unit without connecting the
brake pressure lines, pressure has to be released
from the ABS brake system by pushing button (3).
 If the ABS vessel is under pressure it is possible to
put pressure back on the brakes by pulling button
(3).
When towing a compressor equipped
with tandem axles, take care that the
angle between compressor and towing
vehicle does not exceed 10° (see picture)
- 31 -

TOWBAR LEVELLING WAGON

10˚
10˚
The towbar of the wagon is equipped with an
adjustable spring loaded levelling device.
To adjust:
1. Slide back the rubber bellows (1).
2. Turn the nut (2) clockwise to increase the spring
load for lifting the towbar; turn the nut (2) counter
clockwise to decrease the spring load for lowering
the towbar.
3. Slide the bellows (1) over the nut.
(1)
+
-
(2)