Atlas Copco XAMS 1150 CD7 T3 APP Instruction Manual page 50

Set Language
Press the Settings View button
 scroll to 1000 GENERAL SETTINGS

press Enter

scroll to 1300 LANGUAGES
 Enter the LANGUAGES menu
 Enter the SETTINGS parameter
 scroll to the preferred language
 press Enter.
Now press BACK until you're back in the Main View
(or in the menu you require).
Set Units
Press the Settings View button
 scroll to 1000 GENERAL SETTINGS
 press Enter
 scroll to the unit you would like to change:
1340 TEMPERATURE UNITS
1350 PRESSURE UNITS
1360 FUEL FLOW UNITS
1370 AIR FLOW UNITS
 Enter the preferred menu
 Enter the SETTINGS parameter
 scroll to the preferred setting
 press Enter.
Now press Back until you're back in the Main View
(or in the menu you require).
Change Display Settings
Press the Settings View button.
 scroll to 1000 GENERAL SETTINGS
 press Enter
 scroll to 1310 DISPLAY BACKLIGHT
 Enter the DISPLAY BACKLIGHT menu
 scroll to the setting you would like to change
 press Enter.
To change a setting, the red figure is editable.
Scroll up/down and press Enter to change. Use left/
right to shift between editable figure.
Now press Back until you're back in the Main View
(or in the menu you require).
Go To Diagnostics
Press the Settings View button.
 scroll to 1000 GENERAL SETTINGS
 press Enter
 scroll to 1150 DIAGNOSTICS
 Enter the DIAGNOSTICS menu
 Enter the ENABLE parameter
 scroll to ON and press Enter.
Now the ECU will get PAC (ignition) and one can
perform ECU diagnostics (read DM1 List, DM2 List,
ECU values, perform engine diagnostics, ...).
Now press Back until you're back in the Main View
(or in the menu you require).
To leave DIAGNOSTICS, press the Stop button.
- 50 -
Set the AutoLoad Function
Press the Settings View button.
 scroll to 1000 GENERAL SETTINGS
 press Enter
 scroll to 1160 AUTO LOAD
 Enter the FUNCTION menu
 scroll to AUTO LOAD setting
 press Enter.
Now the AutoLoad function is active, and as soon as
the unit is Ready To Start, the display will show the
Auto Load icon.
Now press Back until you're back in the Main View
(or in the menu you require).