Table of Contents
Advertisement
As the EL light will consume much power it only has to be
Procedure:
1 Power Off the
Anod
MT200
instrument
2 Take off the cover of
the battery and take out
the two batteries
3 Insert the new
batteries into the
instrument
4 Replug the battery
cover
Cat
5 Power on the
M iTe c
instrument to check.
turned on if necessary.
4.16 Battery information
Two AA size alkaline batteries are needed as power
source. After several hours' usage of the preset batteries,
the battery symbol on the screen will be shown as
If battery capacity runs out, the battery symbol
be shown and it will begin to flash. In this case, the
batteries should be replaced.
If the instrument isn't used for a longer period, the batteries
have to be removed.
4.17 Auto Power off
The instrument features an "auto power off" function
designed to conserve battery life. If it is not in use for 5
minutes or more, it will turn itself off. If the voltage of the
battery is too low this function will also work.
4.18 System reset
The
key has to be pressed while powering on the
instrument: factory defaults will be restored.
All the memory data will be cleared during system reset.
The only time this might be helpful is if the parameter in
the instrument was somehow corrupted.
4.19 Connection to PC
This instrument is equipped with a RS-232serial port.
Using the accessory cable, the instrument has got the
ability to connect to a PC or an external storage device.
Measurement data stored in the memory can be
transferred to the PC through the RS-232 port. For detailed
information of the communication software and its usage,
refer to the software manual.
5. Menu operation
TU_US-BA-e-1110
Sauter GmbH
Tieringerstr. 11-15
D-72336 Balingen
E-Mail: info@sauter.eu
Instruction Manual
TU_US
Both, presetting system parameters and the additional
function are verified by menu operation. On the
measurement screen, the
into the main menu.
.
will
5.1 Enter the main menu
To enter the main menu, the key
activate the menu items tab while being on the
measurement screen. To turn back to the previous screen,
the key
5.2 Enter the Sub menu
The
screen while the submenu item is selected.
5.3 Change the parameter
The
parameter while the item is selected on the parameter set
screen.
5.4 Numeric digit input
The
numeric digit to be changed; the numeric values on the
Tel: +49-[0]7433- 9976-174
Fax: +49-[0]7433-9976-285
Internet: www. sauter.eu
key has to be pressed to get
Work mode
2-Point Cal
Velocity Set
Probe Set
Tolerance Limit
Resolution
Unit
Test Set
Print Set
Memory Manager
System Set
System Info
has to be pressed again.
key has to be pressed to enter the submenu
key has to be pressed to change the value of a
key has to be pressed multiple times to tab to the
Print Current
Print Memory
Print All Mem
View Mem Data
Delete by File
Delete all Data
Auto Save
Key Sound
Warn Sound
LCD Brightness
has to be pressed to
9
Advertisement
Table of Contents
