Configuring Scheme Authentication For Telnet Login - HPE FlexFabric 5940 Series Configuration Manual

Step
Enter VTY line view
2.
or class view.
Enable password
3.
authentication.
Set a password.
4.
(Optional.) Assign a
5.
user role.
After you finish this configuration task, a user must provide the configured password when Telnetting
to the device, as shown in the following example:
******************************************************************************
* Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
Password:
<HPE>
If the maximum number of login users has been reached, the login attempt fails and the message "All
user lines are used, please try later!" appears.

Configuring scheme authentication for Telnet login

Step
Enter system view.
1.
Command
•
Enter VTY line view:
line vty first-number
[ last-number ]
•
Enter VTY line class view:
line class vty
authentication-mode password
set authentication password { hash
| simple } password
user-role role-name
Command
system-view
53
Remarks
A setting in user line view applies only
to the user line. A setting in user line
class view applies to all user lines of
the class.
A non-default setting in either view
takes precedence over a default
setting in the other view. A non-default
setting in user line view takes
precedence over a non-default setting
in user line class view.
A setting in user line class view does
not take effect for current online users.
It takes effect only for new login users.
In non-FIPS mode, password
authentication is enabled for VTY lines
by default.
In VTY line view, this command is
associated with the protocol inbound
command. If you specify a non-default
value for one of the two commands,
the other command uses the default
setting, regardless of the setting in
VTY line class view.
By default, no password is set.
By default, a VTY line user is assigned
the network-operator user role.
Remarks
N/A
*
*
*