Performing An Issu By Using Install Commands; Issu Task List - HPE FlexFabric 5940 Series Configuration Manual

Performing a reboot or incompatible upgrade
Step
Verify that the
1.
system is stable.
Load the upgrade
2.
images as startup
images on
subordinate
members.
Verify that the ISSU
3.
is finished.

Performing an ISSU by using install commands

ISSU task list

Tasks at a glance
(Optional.)
(Required.) Perform one of the following tasks to
update software:
•
Installing or upgrading software images
Installing or upgrading images except for
patches
Installing patch images
•
Uninstalling feature or patch images
Uninstalling feature images
Uninstalling patch images
(Optional.)
images
(Optional.)
operation
(Optional.)
Command
display system stable state
•
Use .bin files:
issu load file { boot filename |
system filename | feature
filename&<1-30> } * slot
slot-number [ reboot ]
•
Use an .ipe file:
issu load file ipe ipe-filename
slot slot-number [ reboot ]
display issu state
Decompressing an .ipe file
Rolling back the running software
Aborting a software activate/deactivate
Committing software changes
Remarks
The system is stable if the System
State field displays Stable.
For a successful ISSU, you must make
sure the system is stable before you
proceed to the next step.
Specify the member ID of the device
for the slot slot-number option.
If the ISSU state field displays Init, the
ISSU is finished.
Remarks
To use install commands for upgrade, you must
use .bin image files. If the upgrade file is an .ipe file,
perform this task before you use install commands
for upgrade.
Perform an activate operation to install new images or
upgrade existing images.
Perform a deactivate operation to uninstall feature or
patch images.
An image is added to or removed from the current
software image list when it is activated or deactivated.
Perform this task to roll back running software image
status after activate or deactivate operations.
A commit operation deletes all rollback points. You
can perform this task only before software changes
are committed.
You can perform this task while an image is being
activated or deactivated.
This task is available only for service upgrade or file
upgrade.
This task updates the main startup image list with the
changes.
If service upgrade or file upgrade is performed, you
must perform this task for the changes to take effect
after a reboot.
123