HPE FlexFabric 5940 Series Configuration Manual page 48

a. Add a user account named $enab0$ and set the password to 123456. (Details not shown.)
b. Access the Cisco IOS/PIX 6.x RADIUS Attributes page.
c. Configure the cisco-av-pair attribute, as shown in
Figure 8 Configuring the cisco-av-pair attribute
Verifying the configuration
Telnet to the switch, and enter username test@bbb and password aabbcc to access the
1.
switch. Verify that you have access to diagnostic commands.
<Switch> telnet 192.168.1.70
Trying 192.168.1.70 ...
Press CTRL+K to abort
Connected to 192.168.1.59 ...
******************************************************************************
* Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
login: test@bbb
Password:
<Switch>?
User view commands:
ping
quit
ssh2
super
system-view
telnet
tracert
<switch>
Verify that you can obtain the network-admin user role:
2.
# Use the super password to obtain the network-admin user role. When the system prompts for
a username and password, enter username test@bbb and password 123456.
<Switch> super network-admin
Username: test@bbb
Password:
The following output shows that you have obtained the network-admin user role.
Ping function
Exit from current command view
Establish a secure shell client connection
Switch to a user role
Enter the System View
Establish a telnet connection
Tracert function
40
Figure 8.
*
*
*