Using The Device To Log In To An Ssh Server; Logging In Through A Pair Of Modems - HPE FlexFabric 5940 Series Configuration Manual

Step
(Optional.) Specify
7.
the protocols for the
user lines to support.
Exit to system view.
8.
(Optional.) Configure
9.
common settings for
VTY lines.
10. (Optional.) Set the
maximum number of
concurrent SSH
users.

Using the device to log in to an SSH server

You can use the device as an SSH client to log in to an SSH server. If the server is located in a
different subnet than the client, make sure the two devices can reach each other.
Figure 12 Logging in to an SSH server from the device
Perform the following tasks in user view:
Task
Log in to an IPv4 SSH server.
Log in to an IPv6 SSH server.
To work with the SSH server, you might need to specify a set of parameters. For more information,
see Security Configuration Guide.

Logging in through a pair of modems

You can use a pair of modems to remotely connect to the console port of the device over PSTN when
no IP network connection is available.
Command
•
In non-FIPS mode:
protocol inbound { all |
ssh | telnet }
•
In FIPS mode:
protocol inbound ssh
quit
See "Configuring common
VTY line settings."
aaa session-limit ssh
max-sessions
59
Remarks
In non-FIPS mode, both Telnet and SSH are
supported by default.
In FIPS mode, SSH is supported by default.
A protocol change does not take effect for
current online users. It takes effect only for
new login users.
In VTY line view, this command is associated
with the authentication-mode command. If
you specify a non-default value for one of the
two commands, the other command uses the
default setting, regardless of the setting in
VTY line class view.
N/A
N/A
The default is 32.
Changing this setting does not affect users
who are currently online. If the new limit is
less than the number of online SSH users, no
additional SSH users can log in until the
number drops below the new limit.
For more information about this command,
see Security Command Reference.
Command
ssh2 server
ssh2 ipv6 server