Step
Enter VTY line view or
2.
class view.
Enable scheme
3.
authentication.
To use scheme authentication, you must also perform the following tasks:
•
Configure login authentication methods in ISP domain view.
•
For remote authentication, configure a RADIUS, HWTACACS, or LDAP scheme.
•
For local authentication, create a local user account and configure the relevant attributes.
For more information, see Security Configuration Guide.
After you finish this configuration task, a user must provide the configured username and password
when Telnetting to the device, as shown in the following example:
******************************************************************************
* Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
login: admin
Password:
<HPE>
If the maximum number of login users has been reached, the login attempt fails and the message "All
lines are used, please try later!" appears.
Setting the maximum number of concurrent Telnet users
Step
Enter system view.
1.
Command
•
Enter VTY line view:
line vty first-number
[ last-number ]
•
Enter VTY line class
view:
line class vty
authentication-mode
scheme
Command
system-view
54
Remarks
A setting in user line view applies only to
the user line. A setting in user line class
view applies to all user lines of the class.
A non-default setting in either view takes
precedence over a default setting in the
other view. A non-default setting in user
line view takes precedence over a
non-default setting in user line class view.
A setting in user line class view does not
take effect for current online users. It
takes effect only for new login users.
In non-FIPS mode, password
authentication is enabled for VTY lines by
default.
In VTY line view, this command is
associated with the protocol inbound
command. If you specify a non-default
value for one of the two commands, the
other command uses the default setting,
regardless of the setting in VTY line class
view.
Remarks
N/A
*
*
*