Transmit Delay:
Reinit Delay:
Notification
Interval:
Fast Start Times:
14.1.2 Port Config
On this page you can configure all ports' LLDP parameters.
Choose the menu LLDP→Basic Config→Port Config to load the following page.
Enter a value from 1 to 8192 in seconds to specify the time for
the local device to transmit LLDPDU to its neighbors after
changes occur so as to prevent LLDPDU being sent frequently.
The default value is 2.
This parameter indicates the amount of delay from when LLDP
status becomes "disable" until re-initialization will be attempted.
The default value is 3.
Specify the interval of Trap message which will be sent from
local device to network management system. The default value
is 5.
When the port's LLDP state transforms from Disable (or
Rx_Only) to Tx&Rx (or Tx_Only), the fast start mechanism will be
enabled, that is, the transmit interval will be shorten to a second,
and several LLDPDUs will be sent out (the number of LLDPDUs
equals this parameter). The default value is 3.
Figure 14-2 LLDP Port Config
208