Table of Contents
Advertisement
5-i nch High Speed Dome User Ma nual
Note:
There are 2 auxiliary outputs configurable.
3. Move the cursor to DWELL TIME to set the duration of the auxiliary output signal. The
configurable rage is 0~60 seconds.
4. Link the auxiliary output to the configured alarm.
Steps:
(1) Enter MAIN MENU > DOME SETTINGS > ALARMS > ALARM SETTING and choose the alarm
number that you want to link the auxiliary output to.
(2) Move the cursor to AUX and click IRIS+ to configure the auxiliary output to the alarm. You
can choose NONE to disable auxiliary alarm outputs, choose 1 to active AUX 1 or choose 2 to
active AUX 2.
3.6 Others
3.6.1 Configuring Dome Authentication
Purpose:
You can change and enable/disable the password to set the dome authentication to prevent
unauthorized changes to the dome settings. After you set and enable the password, you need to
input the password every time you call preset 95 to enter the menu.
Steps:
1. Move the cursor to enter password modification submenu:
MAIN MENU > DOME SETTINGS > PASSWORD > EDIT PASSWORD
2. Click IRIS+ to enter edit mode.
3. Click the left/right buttons to move the cursor on the current password and click up/down or
FOCUS IN/OUT buttons to choose the number.
4. Click the right direction button to move the cursor to INPUT PW AGAIN and input the password
again.
5. Click IRIS+ to save the changes and exit.
6. Enter the START USING submenu and switch the status to ON and click IRIS+ to save.
© Hikvision Digital Technology C o., Ltd. All Rights Reserved.
PASSWORD
START USING
ON
EDIT PASSWORD
BACK
EXIT
Figure 3-27
INPUT PW
1 2 3 4 5 6
INPUT PW AG 1 2 3 4 5 6
DONE: OPEN
QUIT: CLOSE
Set the Password
30
Advertisement
Table of Contents
