Table of Contents
Advertisement
5-i nch High Speed Dome User Ma nual
SYS INFO SETTINGS
SOFT ADDRESS
SOFT ADDR ACTIVE
SOFT BAUD
SOFT BAUD ACTIVE
BROADCAST ADDRESS
PELCO CHECKSUM
SYS TIME
BACK
Note:
You can click the left and right direction buttons in the PTZ control panel via the IE browser of
the DVR to enter the next page and return to the previous page of the submenu if more than one
page is available.
Descriptions of system parameter configuration:
Dome address settings
Steps:
1. Set the soft address of the speed dome.
If the SOFT ADDR ACTIVE is set as ON, the soft address is the valid address for connecting the
speed dome. The selectable soft address range is from 1 to 255;
If the SOFT ADDR ACTIVE is set as OFF, the hard address set by the DIP switch is the valid
address of the speed dome (the hard address is set as 0 by default).
Notes:
Before you set the soft address of the speed dome, you need to confirm it's within the
control range of the control device (e.g. the DVR).
After you enable/disable the soft address, the speed dome will reboot automatically to
activate the settings.
2. Set the broadcast address of the speed dome.
When the BROADCAST ADDRESS is set to ON, the control device with address 0 is capable of
controlling all domes connected to it.
Soft baudrate settings
If the SOFT BAUD ACTIVE is set as ON, the soft baudrate is the valid baudrate for the speed dome,
with 2400, 4800, 9600 and 19200 selectable.
If the SOFT BAUD ACTIVE is set as OFF, the baudrate should be set by the DIP switch.
Note:
After you enable/disable the soft baudrate, the speed dome will reboot automatically to
activate the settings.
Protocol and RS-485 settings
Purpose:
This speed dome allows you to configure the protocol via OSD menu.
Steps:
© Hikvision Digital Technology C o., Ltd. All Rights Reserved.
SYS INFO SETTINGS
ZERO ANGLE
1
DISPLAY SETTINGS
OFF
FAN CONTROL
2400
EIS FUNCTION
OFF
EIS LEVEL
ON
PRESET DFOCUS
ON
PROTOCOL STATUS SET OFF
EXIT
System Information Settings
Figure 3-3
TEMP
ON
2
OFF
BACK
EXIT
SYS INFO SETTINGS
PROTOCOL SET
AUTO MATCH
485CHECK SET
AUTO
BACK
EXIT
7
Advertisement
Table of Contents
