Table of Contents
Advertisement
5-i nch High Speed Dome User Ma nual
1. Select the protocol.
Choose the protocol on PROTOCOL SET submenu. You can configure it as AUTO MATCH,
PELCO-P, PELCO-D, HIKVISION, KALATEL or VICON. When you choose AUTO MATCH, it is
protocol self-adaptive.
2. Set the protocol status.
Set the PROTOCOL STATUS SET as ON to enable the user-defined protocol.
3. Enable the RS-485 configuration diagnosis.
You can set 485CHECK SET as ON or AUTO for automatic RS-485 configuration diagnosis. If the
configuration is incorrect, an alert will be received; if you set the value as AUTO, it will
automatically stop the diagnosis when no errors exist.
Note:
If the speed dome uses PELCO-P or PELCO-D protocol, you can set the PELCO CHECKSUM as
ON.
0ºangle (initial position) configuration
Purpose:
You can define the initial position of the speed dome on the ZERO ANGLE submenu.
Steps:
1. Move the cursor to ZERO ANGLE using the direction buttons and click IRIS+ to enter.
2. Click the left/right/up/down direction buttons to adjust the monitor angle of the speed dome to
find the initial position.
3. Click IRIS+ button to confirm and exit.
Other system configurations
1. System time configuration
Steps:
(1) Move the cursor to SYS TIME using the direction buttons and click IRIS+ to enter.
(2) Click the left/right direction buttons to position the cursor on the specific item
(year/month/day or hour/minute/second) of which you want to change the value.
(3) Click the up/down direction buttons to increase/decrease the value.
(4) Click IRIS+ button to confirm and exit.
2. Fan parameter configuration
You can set the FAN CONTROL as TEMP (controlled by the temperature), ON or OFF.
3. EIS (Electronic Image Stabilization) function configuration
© Hikvision Digital Technology C o., Ltd. All Rights Reserved.
Y - M - D
07 01 18
H - M - S
15 33 25
DONE: OPEN
QUIT: OPEN
Set the System Time
Figure 3-4
8
Advertisement
Table of Contents
