Rstp Port Settings - Supermicro MBM-GEM-004 Web User Manual

MBM-GEM-004 Switch Web User Guide
Forward Delay (Seconds) - Specifies how fast a port changes its spanning state when moving
towards the Forwarding state. Forwarding time values from 4 to 30 seconds. The default value is
15.

4.7.3 RSTP Port Settings

The Port Settings link opens the RSTP Port Settings page. The configuration per port related to
RSTP can be done through this page. You are allowed to configure the following:
Port – Specifies the port identifier.
Port Role - Specifies the Port's Current Role, which can be enabled or disabled.
Port Priority – Specifies the port priority used in role selection. Port priority values from 0 to 240.
The default priority value is 128.
RSTP Status – Specifies the RSTP protocol status that can be enabled/disabled on the particular
port.
Path Cost – Specifies the path cost associated with this port. Port priority values from 0 to
200000000. The default path cost is calculated based on the port speed.
Protocol Migration - This is to control the migration from RSTP to STP, if the other side of the
switch runs STP. The migration takes place only if this is enabled.
AdminEdge port - Edge port or non-edge port.
Admin Point-to-Point -You can configure ports explicitly as point-to-point (Force true), or Non-
point-to-point or leave the decision to be made dynamically (from AL or MAC layer).
Auto Edge Detection - Enable or disable the automatically detection of auto edge.
Restricted Role – Specifies the Restricted role status of the port.
Restricted TCN – Indicates the Restricted TCN status of the port.
Release: 1.0 89 / 164