Table of Contents
Advertisement
4 Description
The meter can measure voltage through the probe inputs.
The meter is in full power-saving mode.
4.3 Function buttons
•
Use the button to select Auto select or Manual select mode,
see section 5.2 Auto/Manual select mode, page 14.
•
In Manual select mode, press the button to select the operat-
ing mode.
•
Use the button to select Auto range or Manual range mode,
see section 5.3 Auto/Manual range mode, page 15.
•
In Manual range mode, press the button to change the range
(scale).
Press the button to toggle between Normal and Hold modes, see
section 5.4 Hold mode, page 15.
Holding the button down for 2 secconds enables/disables the key
lock mode.
In Hold mode, the meter will beep continuously and the display
will flash if the measured signal is larger than the display reading
(for the V.A.W. function).
•
Press the button to enable/disable the display backlight.
•
Press and hold the button for 2 seconds to enable/disable the
work light.
Press the button to enable/disable METERLiNK® (Bluetooth)
communication, see section 5.13 Streaming measurement data
using Bluetooth, page 30.
#T559825; r. AI/33557/33557; en-US
10
Advertisement
Table of Contents
