Function Switch; Function Buttons - FLIR CM82 User Manual

4.2 Function Switch
The meter can measure capacitance through the probe inputs.
The meter can measure resistance, continuity, or diode polarity through the
probe inputs. The type of measurement is selected by the MODE button.
The meter can measure power through the probe inputs and the clamp
jaws.
The meter can measure current through the clamp jaws.
The meter can measure voltage through the probe inputs.
The meter is in full power‐saving mode.
4.3 Function Buttons



FLIR CM82 USER MANUAL Document Identifier: CM82‐en‐GB_AD
Use the button to select Auto select or Manual select mode, see section
5.2 Auto/Manual select mode
In Manual select mode, press the button to select the operating mode
Use the button to select Auto range or Manual range mode, see section
5.3 Auto/Manual range mode
In Manual range mode, press the button to change the range (scale)
Press the button to toggle between Normal and Hold modes, see section
5.4 Hold mode
Holding the button down for 2 seconds enables/disables the key lock
mode
In Hold mode, the meter will beep continuously and the display will
flash if the measured signal is larger than the display reading (for the
V.A.W. function).
Press the button to enable/disable the display backlight.
Press this button to enable/disable the work lights.
9