Fluke 9100A Operation Manual page 49

Move the cursor to the next field to the right and
6 .
enter the program name using the operator's keypad.
We will use TEST2 as the program name for this
example. The display should now look like that
below:
EXEC UUT ABC PROGRAM TEST2
7. Press the ENTER key to execute the program
TEST2.
If the UUT name and program name you enter are
not found on the currently selected disk drive, the
error message "PROGRAM DOESN'T EXIST ON
DISK" appears on the display.
If the UUT name and program name are found, the
selected test is executed.
Suppose this UUT has no faults. It would then pass
8 .
the functional test. Your programmer might have
designed a display message such as the following to
tell you what to do next:
TEST2 PASSES.
PLEASE SET UP A NEW UUT FOR TESTING.
If instead, the UUT is defective and the fault is
detected by this test, a message such as the one
below might appear on the operator's display:
TEST 2 FAILS.
USE GFI TO TROUBLESHOOT.