Fluke 9100A Operation Manual page 22

NOTE
If, in step 3 when you pressed the SETUP MENU
key, the display did not look like the one shown in
the figure, you could make it do so by per$orming
the following sequence:
Press the left arrow key enough times to move
l
the cursor all the way to the left.
Press the FI softkey (SETUP).
l
Press the right arrow key once and then press
the FI softkey (POD).
Press the right arrow key once and then press
the Fl softkey (REPORT).
Press the right arrow key once and then press
the FI softkey (POWER).
Press the right arrow key once and press the
l
Fl softkey (ON); then press the left arrow key
enough times to move the cursor all the way to
the left.