HP StorageWorks Modular Smart Array 500 Maintenance And Service Manual page 21

Scsi storage system

Hide thumbs Also See for StorageWorks Modular Smart Array 500:

Table of Contents

Removal and Replacement Procedures

To remove the component:

1. Disconnect the power cord from the power supply.

2. Remove the blower. Refer to "Blower" in this chapter.

3. Remove the power supply.

To replace the power supply:

1. Lift the locking latch.

2. Slide the power supply into the bay until it locks into place.

3. Install the blower on the power supply.

4. Connect the power cord.

If you are replacing AC power supplies with DC power supplies, refer to the DC Power

Supply Option Installation Instructions that ship with the option.

HP StorageWorks Modular Smart Array 500 System Maintenance and Service Guide

2-13

HP CONFIDENTIAL Codename: Aurora Part Number: 251850-004 Last Saved On: 9/19/03 10:57 AM

Table of Contents

Need help?

Do you have a question about the StorageWorks Modular Smart Array 500 and is the answer not in the manual?

Storageworks msa500