Regulatory Approvals; Fcc Notice To Users - Fibocom G610 Hardware User Manual

ETSI TS 100 549 (GSM 03.90 version 7.0.0 Release 1998)
ETSI TS 101 267 (GSM 11.14 version 6.3.0 Release 1997)
ETSI TS 100 977 (GSM 11.11 version 6.3.0 Release 1997)
ITU-T V.25ter
ETSI EN 300 908 (GSM 05.02 version 8.5.1 Release 1999)
ETSI TS 101 356 (3GPP TS 07.60 version 7.2.0 Release 1998)

1.5 Regulatory Approvals

1.6 FCC Notice to Users

The G610 Module has been granted modular approval for mobile applications. Integrators may use
the G610 Module in their final products without additional FCC certification if they meet the following
conditions. Otherwise, additional FCC approvals must be obtained:
1. At least 20cm separation distance between the antenna and the user's body must be maintained at
all times.
2. To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition must
not exceed 2dBi in the cellular band and 2dBi in the PCS band.
3. The G610 Module and its antenna must not be co-located or operating in conjunction with any other
transmitter or antenna within a host device.
4. A label must be affixed to the outside of the end product into which the G610 Module is incorporated,
with a statement similar to the following: For G610: This device contains FCC ID:
ZMOFIBOCOMG610
5. A user manual with the end product must clearly indicate the operating requirements and conditions
that must be observed to ensure compliance with current FCC RF exposure guidelines.
The end product with an embedded G610 Module may also need to pass the FCC Part 15 unintentional
emission testing requirements and be properly authorized per FCC Part 15.
Note: If this module is intended for use in a portable device, you are responsible for separate
approval to satisfy the SAR requirements of FCC Part 2.1093.
G610 GPRS Module Hardware User Manual
Preface
Page 7 of 47