Lpg - Fibocom G610 Hardware User Manual

circuit.
Parameter
T width

3.11.3 LPG

As an alternative to generating the synchronization signal, the control pin can be used to drive a
status LED on application platform. The timing of LPG, it can be indicated the G610 status straight.
Referenced circuits about LED driver see below.
States of the LED vs PIN: LED Off = HIGH. LED On = LOW.
LED state
Permanently off
600 ms on / 600 ms off
3 s on / 75 ms off
75 ms on / 75 ms off
Permanently on
G610 GPRS Module Hardware User Manual
Conditions
Operating status of G610
G610 is in one of the following modes:
• Power off mode
• SLEEP mode
G610 is in one of the following status:
• NO SIM card
• SIM PIN
• Register network (T<15S)
• Register network failure (always)
G610 is in one of the following status:
• IDLE mode
G610 is in one of the following status:
• One or more GPRS contexts activated.
G610 is in one of the following status:
• Voice call
• CSD or FAX call
Min Typ Max
100 200 400
Unit
mS
Page 33 of 47