Bike to DT7 Desk Assembly
A. Position the pre-assembled bike as shown below.
B.
Tilt the front of the bike up and roll it forward under the desk to the
desired position.
Roll Forward
Tilt Back
Desk D-Connector
9 Pin
Data Cable
C. Connect the 9 Pin Data Cable(22) into the
desk D-Connector on the Right Base Foot(7) and bike Data Cable and
tighten the thumb screws.
D. Plug the Power Cord from the back of the bike to a wall outlet.
Bike Connections - Rear View
7
22
DT7 Electric Bike Desk Assembly
Place into Position
Bike Data Cable
Be sure all connectors
are plugged in prior to
connecting the power cord
NOTE:
33