LifeSpan DT7 Owner's Manual page 13

Desk Assembly
Step 1: Attach Right and Left Side Desk Support Brackets
Contents: 6 each M8x12L Screws with Washers
A. Attach the Left Desk Support Bracket(8) to the Left Motorized Leg(5). Each
will have an "LLL" sticker attached for easy identification.
B. Stand the leg on the motor side as shown in the illustration and align the
bracket.
C. Locate the screws for Step 1 and hand tighten the bracket to the leg.
Then securely tighten with the included tool.
D. Repeat for the Right Desk Support Bracket(9) and Right Motorized Leg(4).
NOTE: Make sure that the
power cable isn't set hard
on the ground which could
damage the wire.
NOTE: Do not tighten or
loosen set screws. They
have been pre-adjusted
prior to shipping.
18
LOCATE BAG LABELED STEP 1
5
Set Screws
8
5mm Allen
Wrench w/
Phillips
M8x12L (x6)