LifeSpan DT7 Owner's Manual page 23

Desk Console Assembly
Step 2: Console Assembly
A. Using the 5mm Allen Wrench with Screwdriver remove the two pre-
installed screws from the back and two screws from the bottom of each
console end cap so you can remove the end caps. Notice the difference in
the screws from the back and bottom as you will be replacing them back
into their proper place.
B. For 38" desktops, align the Console(19) with pre-drilled holes in the
Desktop(3). For 48", 60" and 72" desktops, position the Console where you
will use your treadmill or bike base (no pre-drilled holes for 48", 60" and
72" desktop).
C. Using eight M4x15L Screws(23) attach the Console(19) to the Desktop(3).
D. Re-install the end caps with the pre-installed screws you removed in
Step A.
Step 3A: Remove End Caps
Step 3B & C:
Attach Console
3
Step 3D:
Re-install
End Caps
28
Back Screws
23
19
23
19
5mm Allen
Wrench w/
Phillips
Bottom Screws
#8x5/8L
Screw