Connection Mode - Panasonic HL-G1**-A-C5 User Manual

 Connection Mode
This function is used to select the performance settings for measurement
data output to the host device.
Select the operation settings for measurement data output to the host device.
This section provides information on the condition that the RS-422 device is
connected 1-to-1 and the RS-485 device is connected 1-to-N (sensor heads) to the
system. For the connection method,
Specifications - Connecting Example with External Device." For details of the
dedicated output format,
Connection
Setting
method
RS-422
handshake
RS-422
RS-422
Timing
RS-422
Continuous
RS -485
RS-485
Multiple
* indicates the default value.
● Setting Procedure
1
Display the "COM Setting" screen while
in setting mode.
2
Press the [ENTER] key. The "Terminating
Resistor Selection" screen will be displayed.
3
Press the [DOWN] key three times. The
"Connection Mode" screen will be displayed.
4
Press the [ENTER] key. The present
connection mode will be displayed.
5
Press the [UP]/[DOWN] key to change the
connection mode. (Example: Changing the
connection to RS-485 multi connection.)
6
Press the [ENTER] key to determine the
connection mode setting.
Ramco National
refer to "4-1 Communications
refer to "4-2 Type and Format of Commands".
Function
Transmits the result data (a response command)
in response to a request command from the host
device. All commands can be received.
Transmits the measured value in the exclusive
output format when timing input is ON while
the system is in this mode.
Transmits the measured value continuously in
the exclusive output format after this mode is
selected.
Up to 16 sensor heads are connected to the
host device. Transmits the result data (a
response command) in response to a request
command from the host device. No sensors
outside the designated range will not respond.
800-280-6933 | nsales@ramcoi.com
Panel
display
www.panasonicsensors.com