Sensitive Directional Power; Synchrocheck 1; Tracking Frequency - GE F60 Instruction Manual

6.3 METERING
Voltage harmonics are not available on F60 relays configured with the high-impedance fault detection (Hi-Z) fea-
ture.
NOTE
Voltage harmonics are calculated only for Wye connected phase VTs. Ensure the
VOLTAGE BANK F5
NOTE
PATH: ACTUAL VALUES
SENSITIVE
DIRECTIONAL POWER
The effective operating quantities of the sensitive directional power elements are displayed here. The display may be useful
to calibrate the feature by compensating the angular errors of the CTs and VTs with the use of the
settings.
PATH: ACTUAL VALUES

SYNCHROCHECK 1

6
The actual values menu for synchrocheck 2 is identical to that of synchrocheck 1. If a synchrocheck function setting is "Dis-
abled", the corresponding actual values menu item will not be displayed.
PATH: ACTUAL VALUES

TRACKING FREQUENCY

The tracking frequency is displayed here. The frequency is tracked based on the selection of the reference source with the
FREQUENCY AND PHASE REFERENCE
Power System section of chapter 5 for additional details.
6-20
PHASE VT XX CONNECTION
METERING

SENSITIVE DIRECTIONAL POWER

DIRECTIONAL POWER 1
3Φ: 0.000 W
DIRECTIONAL POWER 2
MESSAGE
3Φ: 0.000 W
METERING SYNCHROCHECK
SYNCHROCHECK 1 DELTA
VOLT: 0.000 V
SYNCHROCHECK 1 DELTA
MESSAGE
PHASE:
SYNCHROCHECK 1 DELTA
MESSAGE
FREQ: 0.00 Hz
METERING TRACKING FREQUENCY
TRACKING FREQUENCY:
60.00 Hz
setting in the
SETTINGS
F60 Feeder Protection System
setting is "Wye" to enable voltage harmonics metering.
6.3.3 SENSITIVE DIRECTIONAL POWER
SYNCHROCHECK 1(2)
0.0°
SYSTEM SETUP
6 ACTUAL VALUES
SYSTEM SETUP AC INPUTS
and
RCA CALIBRATION
6.3.4 SYNCHROCHECK
6.3.5 TRACKING FREQUENCY
menu. Refer to the
POWER SYSTEM
GE Multilin