Table of Contents
Advertisement
62
surrounding equipment.
Installing and using the pelvic
support
A pelvic support is an optional device you can purchase
separately from Moving Life and install on your ATTO
according to following instructions:
1. Place the two Velcro Stickers on the back of ATTO
near the back handle as shown in Figure 59. Pill the
protecting tape and stick the Velcro in place using
the self-adhering side. Apply light pressure to
ensure good contact.
Figure 59 - Placing Velcro Stickers
2. Attach the pelvic support belt to the Velcro stickers
as shown in Figure 60. You can use any of the two
parts on any side (left or right).
Figure 60 - Attaching the safety belt to the Velcro stickers
3. Close the pelvic support belt after sited on the
scooter by clicking provided belt clicker as shown in
Figure 61.
OPERATING ATTO
Advertisement
Table of Contents
