Table of Contents
Advertisement
OPERATING ATTO
Forward driving
Place your hands on the handgrips. Move the tiller
to the center position to drive straight forward.
Make sure you are in forward drive mode by
looking at the Direction Arrow on the display. If the
arrow points forward (away from your body to the
front) then you are in Forward Mode. If the arrow
points backwards in the direction of your body than
you should click the Direction Button until you hear
one beep and making sure the Direction Arrow is
pointing forward.
Use your right thumb to operate the drive throttle.
Press the throttle lightly to move forward.
Increase the pressure applied by your thumb to
increase your speed.
To stop ATTO, release all pressure on the throttle.
The throttle will automatically return to the upper
(off) position and your scooter will come to a
gradual stop. Note: Always bring your ATTO to a full
stop before changing direction from forward to
reverse, or from reverse to forward.
Reverse driving
Place your hands on the handgrips.
Use one of your left fingers to press the direction
button located on the left side of the Driving
Console.
You should hear a double beep confirming you are
now driving backwards. If you hear a single beep
you are in forward drive mode and should click the
direction button again.
Use your right thumb to operate the drive throttle.
Press the throttle lightly to move backwards.
Increase the pressure applied by your thumb to
increase your reverse speed.
To stop ATTO, release all pressure on the throttle.
The throttle will automatically return to the upper
(off) position and your scooter will come to a
gradual stop.
You should know that for safety reasons ATTO's
speed in reverse is slower than the maximum speed
set on the speed control dial.
45
Advertisement
Table of Contents
