Table of Contents
Advertisement
OPERATING ATTO
Separating the chassis
Lifting ATTO by yourself may be
challenging for some people and therefore not
recommended. If you have another person to assist
you, we suggest lifting the product together. If you
need to lift ATTO alone, you can separate ATTO into
two segments as described below. Lifting ATTO as a
whole may be too heavy and may cause injury or
damage.
ATTO's front and rear halves (chassis) can be easily and
effortlessly separated in only a few seconds by
operating a knob and two handles. The same technique
applies to putting the two halves back together. This is
very useful when storing ATTO in the trunk or in an
airplane's overhead bins.
1. Make sure the handle bar is secured at an
upright position (see Figure 42).
Figure 42
2. Open both separation levers (see Figure 43). In
case the separation levers require too much
force to operate, you should apply horizontal
pressure on the driving console towards the
center of the scooter. This will release the
pressure on the separation levers and will make
them easier to open.
53
Advertisement
Table of Contents
