Table of Contents
Advertisement
38
2.
Figure 20 Seat height cover
3. Under the cover you will find a metal bracket that
has to be removed. Hold the bracket between your
fingers and lift it out. Remember the bracket
position to make it easier to put it back in place
again.
4. Once the bracket has been removed you should be
able to remove the bulky metal pin (located in one
of the three adjustment holes) holding the seat in
its place. Remove the pin while holding the seat
with your other hand (see Figure 21).
5.
Figure 21 Seat height adjustment holes
6. Now you can adjust the seat to any of the three
holes height and reinsert the pin to hold it in place.
7. Reinsert the metal bracket and the cover.
When the seat is in its highest
position, the scooter will be more inclined to tip over.
Tiller angle adjustment
adjustment must be done by certified technician only,
to prevent injury and damage.
OPERATING ATTO
The tiller angle
Advertisement
Table of Contents
