Table of Contents
Advertisement
OPERATING ATTO
The Steering Rod (tiller) angle can be adjusted in one of
two positions according to user comfort. The default
position will be adequate for most users, larger users
may want the Steering Rod further away from their
body for more space. In order to adjust the angle you
need a 4 mm Allen wrench (hex key).
1. ATTO has to be in the opened position in order to
adjust the tiller angle. Once opened, locate and
release the two Alan (hex) screws shown in Figure
22 while holding the tiller in upright position (you
need to hold the tiller to prevent it from falling
while releasing the screws).
2. Move the tiller into the desired position and tighten
the two screws back again using a thread locker
(such as Loctite).
Figure 22 Steering Rod angle adjustment screws
Driving Console
The Driving Console (your scooter's dashboard)
contains all the controls and display needed for
operating your mobility scooter while driving.
Figure 23 Driving Console overview
ON/OFF and speed control buttons
Figure 24 On/Off and speed control
39
Advertisement
Table of Contents
