Table of Contents
Advertisement
42
B. Press the horn button to sound the horn.
Always use the horn when needed to prevent
accident or injury.
Always bring the mobility scooter to
a full stop before changing the driving direction.
USB port
ATTO is equipped with a general USB charging port
providing up to 1.2A charging current. If an error
accorded, the port is disabled and the scooter will
operate as normal. The error will be reset after
restarting of the scooter's controller (power off/on
cycle).
Display Dimming
Pressing the '+' and '-' buttons simultaneously will
toggle the dimming option.
Bee sounds
Beeps caused by pressing buttons may be enabled or
disabled. To Enable, press the '+' and 'Horn' buttons
simultaneously. To Mute the beeps, press the '-' and
'Horn' buttons simultaneously (horn is always active).
Handle bar grips
Figure 28 Handlebar grip
There are two grips on the handlebar, one on each side.
To change the grips from folded position to drive
position simply lift the grip around its pivot and it will
lock itself in the open position. To fold it back again
(only when you are about to fold ATTO), simply pull the
grip away from the handlebar and down to an angle of
nearly 90 degrees where it will automatically lock itself
in the new position.
near the grip hinge. To prevent injury keep your fingers
OPERATING ATTO
Be careful of pinch points
Advertisement
Table of Contents
