Table of Contents
Advertisement
OPERATING ATTO
New battery MUST be fully charged prior to initial
use of ATTO. ALWAYS fully charge new battery
before initial use or battery life will be reduced.
As a general rule, you should charge your battery at
60% of full charge before placing in storage for long
period of time.
Only use a charger approved by Moving Life.
Use of improper extension cord for the charger
could result in risk of fire and electric shock.
Charging the battery can be done on board and off
board, meaning you can connect the charger when the
battery is in its place inside ATTO or when it is taken out
of ATTO.
Charging the battery
a. The battery should not be emptied. To
maintain good battery state and maximize its
life span always charge the battery when the
battery meter reaches 2 green lines.
b. Before placing the battery for a long period of
time make sure to charge it at about 60% of
full charge.
1. Connect the charger to the electric socket. The
Green LED should turn green to indicate the
charger is properly connected to the socket.
2. Connect the other end of the charger to ATTO's
battery. The charger LED will turn red to indicate
the battery is not fully charge and that charging is
taking place.
3. When the battery is fully charged, the LED will turn
green. This may take up to 6 hours. Once charging
is complete, disconnect the charger from the wall
socket and then disconnect the battery from the
charger.
Battery can be charged either when
connected to ATTO or out of ATTO.
Maximizing battery's life time
Always keep batteries in cool dry
conditions to prevent damage to the battery and
61
Advertisement
Table of Contents
