Table of Contents
Advertisement
OPERATING ATTO
Use a left finger to click the direction button. You
should hear a double beep confirming you are now
driving backwards.
Turn the tiller in the direction in which you wish to
drive backwards.
Note that for safety reasons ATTO's speed in
reverse is slower than the maximum speed set on
the speed control dial.
Driving on slopes
Stopping distance on slopes can be
significantly greater than on level ground
More and more buildings have ramps with specified
degrees of inclination, designed for easy and safe
access. Some ramps may have switchbacks (180
degrees turns) that require you to have good cornering
skills on your ATTO.
Proceed with extreme caution as you approach the
downgrade of a ramp or other incline.
Take wide swings with your ATTO around any tight
corners. If you do that, the scooter's rear wheels
will follow a wide arc, not cut the corner short, and
not bump into or get hung up on any railing
corners.
When driving down a ramp, keep ATTO's speed set
to the slowest speed setting to ensure a safely
controlled descent.
Avoid sudden stops and starts.
When climbing an incline, try to keep ATTO moving. If
you must stop, start up again slowly, and then
accelerate cautiously. When driving down an incline, do
so by adjustment the speed to the slowest setting and
driving in the forward direction only. If your scooter
starts to move down the incline faster than you
anticipated or desired, allow it to come to a complete
stop by releasing the throttle. Then push the throttle
forward slightly to ensure a safely controlled descent.
When climbing an incline, do not
zigzag or drive at an angle up the face of the incline.
Drive your ATTO straight up the incline. This greatly
reduces the possibility tipping over or falling. Always
47
Advertisement
Table of Contents
