CHAPTER 3: INTERFACES
889 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL
Figure 3-17: Quick Setup window
•
Settings names and units can be viewed at this screen. To view the range of the
settings, hover the cursor over the setpoint value field.
•
The user can configure and save the settings as required.
•
The Save, Restore and Default buttons function the same as in the individual setting
setup screens.
•
Attempting to enter and save a setting value which exceeds the range gives a
warning dialog box. (note the value is not replaced with the maximum value of the
setting). The user must correct the setting value and save to proceed.
Example:
The Phase CT Primary value has a setting range of 1 to 12000, but the user
enters 12001 and tries to save it. Quick Setup displays a warning dialog. Pressing OK
leaves the setting value at 12001, but not 12000 (max. value) as is the case with other
views.
SOFTWARE INTERFACE
3–33