Automatic Setting Of Waveform Display - UNI-T UTD1025CL Manual

Hide thumbs Also See for UTD1025CL:

Table of Contents

UTD1000L User Manual

Picture 4-8 Adjust Trigger Level

Notes: press key SELECT to change the function

needed to adjust between the channel vertical

shifts and trigger level The above operations

shall be detailed in the following chapters.

Automatic Setting of Waveform Display

UTD1025CL oscilloscope has the automatic

setting function Based on the input signal, it is

possible to automatically adjust vertical deflection

coefficient, scanning time base and trigger modes

until the proper waveform display In application

of automatic setting frequency of the measured

signal is required to be bigger than or

equivalent to 20Hz duty ratio bigger than 1 .

Full-Automatic Setting of Input Signal

UTD1025CL oscilloscope has the creative

function of full-automatic signal capturing. Under

the function the oscilloscope shall adjust gear

automatically with the changes of input signal

and display the waveform in the fittest form

without manual intervention

The following steps shall be taken to operate the

full-automatic setting function:

﹪

Table of Contents

Show Quick Links

Table of Contents