Enabling Bfd For Rsvp - Huawei Quidway S9300 series Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS
Context
Do as follows on the two RSVP neighboring nodes between which a Layer 2 device resides:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd
BFD is enabled globally.
----End

3.19.3 Enabling BFD for RSVP

You can enable BFD for RSVP in either of two modes, that is, enabling BFD for RSVP globally
and enabling BFD for RSVP on RSVP interfaces.
Context
Enabling BFD for RSVP can be realized in the following manners:
l
l
Procedure
l
Issue 04 (2011-12-26)
Enabling BFD for RSVP Globally
RSVP.
Enabling BFD for RSVP on the RSVP Interface
need BFD for RSVP.
Enabling BFD for RSVP globally
Do as follows on both RSVP neighboring nodes between which a Layer 2 device resides:
1. Run:
system-view
The system view is displayed.
2. Run:
mpls
The MPLS view is displayed.
3. Run:
mpls rsvp-te bfd all-interfaces enable
BFD for RSVP is enabled globally.
After this command is run in the MPLS view, BFD for RSVP is enabled on all RSVP
interfaces except the interfaces with BFD for RSVP that are blocked.
4. (Optional) Block BFD for RSVP on the RSVP interfaces that need not BFD for RSVP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
if most RSVP interfaces on a node need BFD for
if certain RSVP interfaces on a node
3 MPLS TE Configuration
252