Huawei Quidway S9300 series Configuration Manual page 185
Terabit routing switch; mpls
Hide thumbs
Also See for Quidway S9300 series:
- Configuration manual - network management (630 pages) ,
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS
The system view is displayed.
Step 2 Run:
interface tunnel interface-number
A tunnel interface is created and the tunnel interface view is displayed.
It is recommended that a tunnel interface be configured on the main control board. That is, the
slot ID of tunnel-number is specified as the slot ID of the main control board. Usually, the slot
ID of the main control board is 0. In the case of the tunnel interface is configured on an interface
board, the tunnel interface is deleted if the interface board is restarted.
Step 3 To configure the IP address of the tunnel interface, select one of the following commands.
l Run:
l Or, run:
To forward traffic, the tunnel interface must have an IP address. However, because the MPLS
TE tunnel is unidirectional, it is unnecessary to configure the IP address separately for the tunnel
interface. The tunnel interface often borrows the LSR ID of the ingress node as the address.
Step 4 Run:
tunnel-protocol mpls te
MPLS TE is configured to be the tunnel protocol.
Step 5 Run:
destination ip-address
The destination address of the tunnel is configured, which is usually the LSR ID of the egress
node.
Different types of tunnels have different requirements for the destination address. When the
tunnel protocol is changed to MPLS TE, the destination configuration is deleted automatically
and needs to be re-configured.
Step 6 Run:
mpls te tunnel-id tunnel-id
The tunnel ID is configured.
Step 7 Run:
Issue 04 (2011-12-26)
CAUTION
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the tunnel interface is configured.
The secondary IP address of the tunnel interface can be configured only after the primary IP
address is configured.
ip address unnumbered interface interface-type interface-number
The tunnel interface is configured to borrow an IP address from another interface.
NOTE
Because the MPLS TE tunnel forwards MPLS packets, the commands, such as the ip verify source-
address and urpf commands, related to IP packet forwarding are invalid for this interface, .
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 MPLS TE Configuration
172
Advertisement
Table of Contents
