Checking The Configuration; Configuring Rsvp Authentication; Establishing The Configuration Task - Huawei Quidway S9300 series Configuration Manual
Terabit routing switch; mpls
Hide thumbs
Also See for Quidway S9300 series:
- Configuration manual - network management (630 pages) ,
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS
The reservation confirmation is initiated by the receiver of Path message. An object that requires
confirming the reservation is carried along the Resv message sent by the receiver.
----End
3.6.6 Checking the Configuration
After adjusting RSVP signaling parameters, you can view the refresh parameters, the status of
RSVP reservation confirmation and RSVP Hello extension, and the RSVP status timer
configuration.
Procedure
l
l
l
l
----End
Example
If the configurations succeed, run the preceding commands and you can view the following
information:
l
l
3.7 Configuring RSVP Authentication
RSVP authentication can prevent unauthorized nodes from setting up RSVP neighbor
relationships with the local node and prevent phishing of forged packets.
3.7.1 Establishing the Configuration Task
Before configuring an RSVP authentication, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Issue 04 (2011-12-26)
NOTE
Receiving ResvConf messages does not mean that the resource reservation succeeds. It means that,
however, resources are reserved successfully only on the farthest upstream node where this Resv message
arrives. These resources may be preempted by other applications later.
Run the display mpls rsvp-te [ interface [ interface-type interface-number ] ] command
to check related information about RSVP-TE.
Run the display mpls rsvp-te psb-content [ ingress-lsr-id tunnel-id lsp-id ] command to
check information about RSVP-TE PSB.
Run the display mpls rsvp-te rsb-content [ ingress-lsr-id tunnel-id lsp-id ] command to
check information about RSVP-TE RSB.
Run the display mpls rsvp-te statistics { global | interface [ interface-type interface-
number ] } command to check RSVP-TE statistics.
Refresh parameters of the interface
Confirmation of the resource reservation, the state of the Hello extension, and the
configurations of RSVP-TE status timers.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 MPLS TE Configuration
186
Advertisement
Table of Contents
