Table of Contents
Advertisement
Programming for the Epic 950
Epic 950 OEM Integration Manual
POR.INI File Parameter Definitions
[Dipswitch n]
The parameter after the [Dipswitchn] will be set if the corresponding dip switch is active.
The list on the previous page is the default settings for dip switches. The dip switch
definitions may be changed as required.
NOTE: Dip switches 1 and 2 cannot be altered in the POR.INI file.
DefaultFont
This parameter defines the font to be used to print text in this field. The first number is
the point size of the font and the second number is the font width ratio (a parameter
which is currently reserved for future use, but must have a value specified). The third
number is the attribute where 0=No attribute, 1=Bold, 2=Italics, and 3=Bold and Italics.
Example:
DefaultFont = 10:45:1
BezelLength
This parameter specifies the length of the paper feed needed to accommodate various
bezels. This parameter is in millimeters.
Example:
BezelLength = 30
Substitute
This parameter defines the Substitute text printed in place of the text sent by the host.
This is a global setting.
Example:
Substitute = ticket|voucher
(replaces occurrences of ticket with voucher)
Zstatusbit3alwaysHigh
This parameter defines the status response on the [GS]z command. If this is set On bit
3 on the status response will always be set high. This is to maintain backward
compatibility to older Series 800 firmware versions.
Example:
ZstatusBit3AlwaysHigh = Off
ColorMode
This parameter set the printer in mode to print color tickets. It should be set On when
using color ticket stock.
Example:
ColorMode = Off
DemoMode
This parameter will force the printer in print a pre-defined ticket for demo purposes only.
The printer will print the pre-defined ticket when it receives a Form Feed Command.
Example:
DemoMode = Off
Page 66
95-05245
Rev G
Advertisement
Table of Contents
