Accelerated Care Plus OMNISTIM FX2 PRO User Manual page 46

® 2
OMNISTIM FX PRO USER MANUAL
HAND CONTROL:
MFAC Hand Control:
LVPC Hand Control:
TIMER FUNCTIONS:
Treatment Timer:
Channel Timing:
TIMING SELECTIONS:
Ramp Time:
ON Time:
OFF Time:
PATIENT SAFETY SYSTEMS:
Activation:
MISC.:
Certificates and Approvals:
CAUTION: Federal law restricts this device to sale by or on the order of a physician (or other health
practitioner licensed by their State).
ACP reserves the right to change technical specifications and product availability without notice.
COPYRIGHT © 2004 - 2017, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED

Modified Sine wave into physiologic load 2 KHz, 2.5 KHz, 4 KHz , 5 KHz AND 10 KHz carrier
frequency

Burst rate adjustable from 0.1 to 999bps, 50% duty factor

Rate scan from 0-50% programmable with scan time, programmable from 0-20 seconds

Asymmetrical biphasic square wave

Phase duration adjustable from 10 - 300 µs

Pulse rate adjustable from 0.1 – 250 pps
Adjustable for 1-99 minutes in one minute increments. Turns output to zero and system off and sounds 10-
second buzzer to indicate completion of treatment.
In alternating mode channels follow each other sequentially. In simultaneous modes the output is
simultaneous. In delayed mode channel B is delayed.
Adjustable from 0.1 to 9.9 seconds in 0.1-second increments. Ramps overlap in NMES Alt mode or with
channel delay.
Adjustable from 1 to 30 seconds in 1-second increments
Adjustable from 0 (continuous) to 199 seconds in 1-second increments
Patient safety hand control shuts down output. Output modality may not be changed during operation. Output
levels are reset to zero at the start and completion of treatment.
Devices are designed to meet or exceed all safety requirements of a medical device in its class per IEC
60601 and CSA C22.2 No. 601.1
- 45 -