Accelerated Care Plus OMNISTIM FX2 PRO User Manual page 14

® 2
OMNISTIM FX PRO USER MANUAL
The bar graph on the lower right of the display shows the relative outputs of the two channels primarily with
respect to Time On and Time Off and Vector operation. The numeric displays on the lower left show the output
intensities into a 500-ohm load. Each time a treatment is commenced, the output current level is reset to zero;
this ensures that your patient cannot receive an initial shock due to the current output, inadvertently, being left
at a high setting from a previous treatment. The patient safety switch is a remote duplicate of the Start/Stop
switch and therefore resets the outputs to zero.
NOTE: In some protocols using alternate or delayed modes, the system will allow set up of output A followed by set
up of output B.
5. Adjust the output intensity by pressing the up/down arrow buttons (3) for channel A and Channel B. When the
desired output is obtained, press the START/STOP button (4) to begin treatment. The following screen will be
displayed:
At this time, the timer display on right side of the screen will display the selected treatment time, and will
continuously display time remaining during treatment.
6. During operation most of the parameters may be altered within the program at will by selecting the set mode.
See set mode operation and adjustable parameters for each modality.
7. Once the treatment is completed, remove the electrodes from the patient and disconnect the lead wires from the
electrodes.
8. Turn the unit off by pressing the POWER button (1/5).
COPYRIGHT © 2004 - 2017, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
NEURO RE-ED
TENS-LVPC MOTOR
LVPC TENS 4.0 Hz
A: 19 mA B: 19 mA 200 µS
T15
13