Air Filter-Regulator Assembly Input And Output Connections; Connecting Travel Sensor Without An Ir Sensor Connected To The Power Source - Miller 301182 Owner's Manual

5-11. Air Filter-Regulator Assembly Input And Output Connections

5-12. Connecting Travel Sensor Without An IR Sensor Connected To The Power Source

2
Back
OM-261823 Page 16
3
1
Front
4
3
Front
1
Filter-Regulator assembly showing
drain fittings and hose installation.
2
Install customer supplied (1/4 in.
NPT) fitting here.
1
3
2 Use air-splitter when using two
Rolling Inductors.
4
4
1 Travel Sensor Cable
Connect 14-pin end of supplied travel sensor to the
back of the power source.
Connect 4-pin end of the cable to the travel sensor
cable.
2 14-Pin Pigtail
For use with optional on/off remote.
3 Cable Clamp
Remove screw from bottom left side of power
source. Attach cable clamp to the front of the pow-
er source using longer screw provided.
4 Hook And Loop Strap
Once cable clamp is installed and cables are con-
nected to the power source, secure cable assem-
bly to the cable clamp using the hook and loop
strap.
Back
Air Filter-Regulator Assembly
Air Inlet Fitting
Air-Splitter
Pneumatic tubing to IR
assembly.
Ref. 277 853-A
262 416-A