Miller 301182 Owner's Manual page 29

This Chart Depicts The Maximum KW/IPM When Travel Detect Is Set To On
35
30
25
20
15
10
5
0
0 10
Notes
Two Rolling Inductors
One Rolling Inductor
20 30
Travel Speed IPM
.
It is recommended to test part temperature
at various travel speeds to ensure the de-
sired heat input rate. For slower rates, out-
put power level can be reduced in the fol-
lowing screens:
1. Max Output setting of the ProHeat 35
in the System Setup Screen
2. Command in the Program screen for
Manual Control mode
Travel Speed:
It is recommended to start testing at lower
KW output and increase as needed.
For thin material, slow travel speed may
provide thorough heating in one or two
passes.
Thicker materials may require multiple
passes to bring a part up to the desired
40 50
temperature. Faster travel speeds provide
more frequent heat input and reduce heat
loss between passes. It is recommended
to test heat times at various travel speeds
to achieve the optimum heating rate.
NOTICE −Excessive heating may dam-
age workpiece.
The ProHeat 35 can restrict the maxi-
mum KW output to the Rolling Inductor
when a Travel Detect is utilized.
OM-261823 Page 23