Mounting Arm To Stand - Miller 301182 Owner's Manual

5-5. Mounting Arm To Stand

3 4
.
Rolling Inductor shown
without accessories.
10
OM-261823 Page 12
6
5
9
11
7
2
1
Customer supplied pipe stand must be capa-
ble of maintaining an upright position with-
out tipping with mounting arm, Rolling In-
ductor, and accessories installed.
Do not step or stand on mounting arm or pipe
stand.
1 Pipe Stand (Customer Supplied)
2 Pipe (Customer Supplied)
1.50 to 2.00 in. (38.1 to 50.8 mm) outer diameter.
3 Rolling Inductor
8 4 Handle Tube
5 Swivel Shaft
6 Mounting Arm
7 Quick-Release Pin
Attach Rolling Inductor to mounting arm by sliding
handle tube over the swivel shaft and secure with
quick-release pin.
8 Knob
Tighten knob to secure arm in place.
9 Eye Bolt
Cable tie output cable to eye bolt.
10 Locking Wheels
If customer supplied stand has wheels, lock wheels
once Rolling Inductor is positioned on workpiece.
11 Adjustable Thumb Screws
Tighten or loosen screws to control motion of the
swivel shaft. If on an elbow, tighten the screw on the
elbow side of the arm to keep inductor from rotating
down as the elbow rotates.
NOTICE −When removing the Rolling Inductor from
the workpiece, do not release the handle until the
Rolling Inductor is in a rest position (straight out or
folded back). Dropping the Rolling Inductor may
damage it.
Verify the stand setup is stable before run-
ning equipment.
264 043-D