Water Tank - Hitachi EP-M70E Instruction Manual

Cleaning
4
Rinse the water tank and tank cover with water and check the movement
of the float switch.
Rinse in running water for 2-3 times.
Do not use detergent.
Check if the float switch can move up and down.
Do not to remove the float switch, or subject it to
unnecessary force.
Otherwise "Water Refill" will not be detected.
5
Put water in the water tank and place the tank cover.
Fill the water tank, making sure it does not exceed the fill line found at
the side of the water tank.
Wipe the moisture around the water tank.
When filling the water tank away from the unit, attach the tank
cover and hold it in place.
If the water exceeds the fill line, it may cause water leakage.
Securely attach the tank cover.
If it is not securely attached, it may cause water leakage
during operation.
6
Install the water tank to the unit
Wipe off water drops in the water tank holder during
installing the water tank.
The unit cannot operate without the water tank.
Securely install the water tank, making sure that it
reaches the back of the unit.
If it is not securely installed, it may cause water
leakage during operation.
Also, hold down the unit to make sure that the unit will
not move during installation.
CAUTION
The water tank may be heavy when filled with water.
Be careful not to injure your fingers, nails, or your
back while handling.

Water Tank

 Replace water daily with fresh tap water.
(Discard any remaining water in the tank)
 Pour a small amount of tap water, tighten the water tank cover, make
sure that the water does not leak, and shake to wash. (Replace the
water and repeat 2 to 3 times)
E-32
EP-M70E_EN.indd 32 EP-M70E_EN.indd 32
(Continued)
CAUTION
CAUTION
CAUTION
(Guide for Cleaning: Daily)
Float switch
Make sure that the water
does not exceed the line.
Tank cover
Water tank holder
Water tank
Water tank
Water level
Water tank
Water inlet
Tank cover
Water tank
2017/2/23 17:27:45 2017/2/23 17:27:45