Hitachi EP-M70E Instruction Manual page 15

4
Install the filter assembly to the unit
CAUTION
Do not put excessive force and deform
the filter assembly.
If the filter assembly is deformed, it will
not be detected by the unit.
" " will be displayed on the
temperature / humidity monitor, and the
unit will not be able to operate.
Install the pre-filter to the unit
5
Securely plug the tabs of the pre-filter to the matching holes in the unit.
Slide the switch downwards (2 locations) to lock.
Gently pull the pre-filter to make sure it is not out of place.
Plug the tabs of the pre-filter
6
Attach the rear panel to the unit
Plug the tabs (2 locations) of the
upper part of the rear panel to
the matching holes in the unit.
Gently push the bottom sides of
the panel one after another, and
close it securely until it clicks.
EP-M70E_EN.indd 15 EP-M70E_EN.indd 15
Set the filter assembly so that you can see the label
(P.E-39)
Tab
Switch
Insertion hole
Insert to the hole
Deodorizing filter
Filter assembly
Slide the switch downward.
Pre-filter
Continued on next page
E-15
2017/2/23 17:27:42 2017/2/23 17:27:42