Advertisement
АМM-3320
8. HOLD key
Used to maintain the measurement data unchanging, by pressing the key again it will resume the measurement.
9. D/Q/ESR key
In L/C measurement mode, press the key to select parameters of D/Q/θ/ESR.
10. SETUP key
When sorting mode is active, press SETUP key to modify the reference value, range and the tolerance settings sequentially.
11. SER/PAL key
Used to select series and parallel mode.
12. FREQ key
Press FREQ key to select five different test frequencies in turn: 100/120/1k/10k/100kHz
13. REL% key
Press REL% key to enter into relative measurement mode. In auto LCR mode, this key is not available.
9
Advertisement
