Advertisement
3. Resistance measurement
1) Turn on the power.
2）There are two ways for resistance input:
a. Insert the measured resistance into the input terminal directly (shown in figure 12);
b. Connect the alligator clips to the ends of the measured resistance (shown in figure 13).
3）The default test mode is Auto LCR mode, the resistance value will show on primary display and the phase angle θ will show
on secondary display. In Auto LCR mode, the D/Q/ESR key, SEL/PAL key, SORTING key and REL% key are not
available.
4）Press FUNC. key three times to select Auto-R (ACR) mode. The primary LCD display will show the resistance value. The
secondary parameter is omitted and the D/Q/ESR key is not available.
5）Press FREQ key to select frequency value: 100/120/1K/10k/100kHz.
6）Press SER/PAL key to select series or parallel mode.
7）Press FUNC. key four times to select DCR mode. The primary LCD display will show the resistance value. The secondary
parameter is omitted and the D/Q/ESR key, SEL/PAL key and FREQ key are not available.
Note: The phase angle θ will show on secondary display only in Auto-LCR mode. During Auto-R mode or DCR mode, the
secondary parameter is not available.
22
АМM-3320
Advertisement
